Designed for active leaks with a pressure boundary up to 100 psi, the LeakStop™ system is a mechanical clamping solution consisting of a sized Fiber Reinforced Plastic (FRP) shell lined with a gasket and secured by metallic compression bands. The LeakStop™ system is available with gaskets not only for standard service, but also for chemical service applications. The system provides complete fit-up integrity between the sealing gasket pad and the pipe, creating a compression seal to stop the leak. Temperature-rated to 250° F, the system installs quickly with minimal down time.
Properties
Mechanical Properties
Attribute Tensile Strength
Method ASTM D 3039
Value 54,000 psi
Attribute Compression Strength
Method ASTM D 695
Value 28,500 psi
Attribute Barcol Hardness
Method ASTM D 2583
Value 53
Thermal Properties
Attribute Max. Operating Temperature
Value 250 °F (121 °C)
Attrbute Max. Application Temperature
Value 250 °F (121 °C)
System Properties
Attribute Wear Pad Thickness
Value 0.25 inches (6.35 mm)
Installation Procedure
1. Position and Secure LeakStop™ Pad

Position the LeakStop™ pad over the defect. Secure the stainless steel banding clamp over the pad center and tighten the band until the leak stops.
2. Position and Secure Remaining Bands

Position and tighten each band using the tensioning tool. Media blast or grind the remaining repair area to create a clean anchor patter, then solvent wipe the surface.
3. Apply Load Transfer Putty to Band Clamps

Knead putty until uniform in color. Then apply the putty to the band clips using a “tented profile.”
4. Apply Epoxy Paste

Mix and apply a 30 mil coating of epoxy paste. Allow the paste to thicken for 10-15 minutes – a “peanut butter” consistency is desired.
5. Apply Pipe Wrap® and Topcoat

Apply provided PipeWrap® using the cigar wrap method. A topcoat may be applied after two hours.
Technical Data Sheet
Click here to review the technical data sheet.
[CONTACT_FORM_TO_EMAIL id=”1″]