The SplashGard™ system is a specialized coating system designed to easily adhere to wet steel surfaces and prevent corrosion. It is comprised of SplashBond™ Adhesive undercoating and Splash Wrap fiberglass cloth outerwrap, impregnated with moisture cured urethane (MCU) resin. The SplashGard™ system not only resists wave action and corrosion, but can also be applied underwater to provide structural reinforcement – perfect for use on risers.

Mechanical Properties

Attribute Tensile Strength
Method ASTM D3039
Value 51,800 psi

Attribute Tensile Modulus
Method ASTM D3039
Value 3.01 x 106 psi

Attribute Poisson’s Ratio
Method ASTM D3039
Value 0.077

Thermal Properties

Attribute Thermal Expansion
Method ASTM E831
Value 10.2 ?m/m/°C

Attribute Heat Distortion Temperature
Method ASTM D648
Value 205 °C

Attribute Max Operating Temperature
Method ASME PCC-2
Value 185 °C

Attribute Application Temperature
Value -50°F to 120°F -46°C to 49°C

System Properties

Attribute Ply Thickness
Value 22 mils (0.022 inches)

Attribute Working Time
Value 20 – 30 minutes

Attribute Set Time
Value 2 hours

Attribute Cure Time
Value 24 hours

Attribute Shelf Life
Value 1 year with proper storage

Attribute Stocked Sizes
Value From 2″ X 12′  to 12″ X 90′

1. Surface Preparation 
Remove all soft coatings and media blast the pipe to provide an anchor pattern (NACE 1 preferred). On dry surfaces, wipe the surface with a solvent such as Acetone, Toluene, or MEK. For structural repairs, mix and apply filler putty or paste to any defects.

2. Apply SplashBond™ 
Mix equal parts of the SplashBond™ Epoxy Primer until uniform. Apply the primer to the pipe surface as instructed. Allow the primer to sit until a “peanut butter” thickness is achieved.

3. Apply SplashWrap™ 
Follow the wrapping instructions for Pipe Wrap™ or A+ Wrap™, as applicable for the repair.

4. Apply SplashBond™ Outer Coat 
Allow the material to cure. Then, mix and apply a coating of SplashBond™ as an outer coating.



HP: 0811-110-3650 (DIMAS)